{"product_id":"rfd-868x-eu-radio-modem-uk-and-europe-bundle","title":"RFD 868x-EU Radio Modem (UK and Europe) - Bundle","description":"\u003cp\u003eChoose a FC Cable separately, we recommend powering the RFD on your drone separately and not from the Telemetry port. The FRD radio modems require 5-6v and up to 800mA. Also available are the Aero Link adapter boards and bases. \u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eIncludes\u003c\/strong\u003e\u003c\/p\u003e\n\u003cul\u003e\n\u003cli\u003e2 x RFD868x-EU Radio Modems\u003c\/li\u003e\n\u003cli\u003e1 x Antenna, 868-900MHz Quarter wave monopole 2.1dBi\u003c\/li\u003e\n\u003cli\u003e1 x Antenna, 868-900MHz Right Angle Quarter wave monopole 2.1dBi\u003c\/li\u003e\n\u003cli\u003e4 x Antennas, 868-900MHz Half wave dipole 3dBi\u003c\/li\u003e\n\u003cli\u003e1 x FTDI USB cable\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003ePlease order connection cable separately \u003c\/p\u003e\n\u003cp\u003e \u003c\/p\u003e\n\u003cp\u003e \u003c\/p\u003e\n\u003ch2\u003eRFD868x-EU New Features:\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003eNew Processor, ARM 32 bit core.\u003c\/li\u003e\n\u003cli\u003eAir data rate: 500kbit\/s.\u003c\/li\u003e\n\u003cli\u003eAES Hardware accelerated encryption. *Fully working*\u003c\/li\u003e\n\u003cli\u003eRC PPM Passthrough with telemetry at the same time.\u003c\/li\u003e\n\u003cli\u003eFully ESD protected + filtered - Every IO port is protected and filtered.\u003c\/li\u003e\n\u003cli\u003eOriginal SiK point to point firmware implemented.\u003c\/li\u003e\n\u003cli\u003eNote: Currently due to the bandwidth limitations of the 868 modems Asynchronous Mesh and Multipoint Firmware are not officially supported for the 868X modems and correct operation of this code cannot be guaranteed\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eFeatures:\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003eLong range \u0026gt;40km depending on antennas and GCS setup *80km demonstrated by Edge Research labs on a balloon !, 57km in India, on Dipoles.\u003c\/li\u003e\n\u003cli\u003e2 x RP-SMA RF connectors, diversity switched.\u003c\/li\u003e\n\u003cli\u003eTransmit low pass filter.\u003c\/li\u003e\n\u003cli\u003e\u0026gt; 20dB Low noise amplifier, high IP3.\u003c\/li\u003e\n\u003cli\u003eRX SAW filter.\u003c\/li\u003e\n\u003cli\u003eAll I\/O ESD protected and filtered.\u003c\/li\u003e\n\u003cli\u003eRe implemented SiK and Multipoint SiK firmware, field upgradeable, easy to configure.\u003c\/li\u003e\n\u003cli\u003eSmall, light weight.\u003c\/li\u003e\n\u003cli\u003eNote: Not compatible with older modems\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003e Interfaces:\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003eRF : 2 x RP-SMA connectors\u003c\/li\u003e\n\u003cli\u003eSerial: Logic level TTL (+3.3v)\u003c\/li\u003e\n\u003cli\u003ePower: +5v, ~800mA max peak (at maximum transmit power)\u003c\/li\u003e\n\u003cli\u003eGPIO: 6 General purpose IO (Digital, ADC, PWM capable).\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eSpecifications:\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003eFrequency Range:  868-869 MHz\u003c\/li\u003e\n\u003cli\u003eAir Data transfer rates: 12, 56, 64, 100, 125, 200, 224, 500 and 750 kbit\/sec (User settable, 64kbit default)*\u003c\/li\u003e\n\u003cli\u003eUART data transfer rates: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400, 460800, 1M baud (User settable, 57600 default)**note these values are correct as of version 3.07 SiK firmware\u003c\/li\u003e\n\u003cli\u003eReceive Sensitivity: \u0026gt;121 dBm at low data rates, high data rates (TBA)\u003c\/li\u003e\n\u003cli\u003eSize: 30 mm (wide) x 57 mm (long) x 12.8 mm (thick) - Including RF Shield, Heatsink and connector extremeties\u003c\/li\u003e\n\u003cli\u003eWeight: 14.5g\u003c\/li\u003e\n\u003cli\u003eMounting: 3 x M2.5 screws, 3 x header pin solder points\u003c\/li\u003e\n\u003cli\u003ePower Supply: +5 V nominal, (+3.5 V min, +5.5 V max), ~800 mA peak at maximum power\u003c\/li\u003e\n\u003cli\u003eTemp. Range: -40 to +85 deg C, tested operational from -73 to +123 deg C.\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eSoftware \/ GCS Support:\u003c\/h2\u003e\n\u003cp\u003eThe software solution is an open source development called \"SiK\".  It has been re implemented to suit the new processor architecture available on the 32bit ARM processor core.  A boot loader and interface is available for further development and field upgrade of the modem firmware via the serial port. Most parameters are configurable via AT commands, Eg. baud rate (air\/uart), frequency band, power levels. Integrated support for configuring the RFD900 radios is supported by APM Planner. The default settings are at 57600 baud, N, 8, 1, and 64k air data rate. The RFD868\/900x manual is here:\u003cspan\u003e \u003c\/span\u003e\u003ca href=\"http:\/\/files.rfdesign.com.au\/Files\/documents\/RFD900x%20DataSheet.pdf\"\u003eRFD900x Manual\u003c\/a\u003e\u003cspan\u003e \u003c\/span\u003eThe RFD868\/900x SiK software manual is here :\u003cspan\u003e \u003c\/span\u003e\u003ca href=\"http:\/\/files.rfdesign.com.au\/Files\/documents\/RFD900x%20Peer-to-peer%20User%20Manual.pdf\"\u003eRFD900x Peer-to-peer Manual\u003c\/a\u003e\u003cspan\u003e \u003c\/span\u003e\u003cstrong\u003eSoftware features include:\u003c\/strong\u003e\u003c\/p\u003e\n\u003cul\u003e\n\u003cli\u003eFrequency hopping spread spectrum (FHSS)\u003c\/li\u003e\n\u003cli\u003eTransparent serial link\u003c\/li\u003e\n\u003cli\u003ePoint to Point, or Multipoint networking\u003c\/li\u003e\n\u003cli\u003eConfiguration by simple AT commands for local radio, RT commands for remote radio\u003c\/li\u003e\n\u003cli\u003eUser configurable serial data rates and air datarates\u003c\/li\u003e\n\u003cli\u003eError correction routines, Mavlink protocol framing (user selectable)\u003c\/li\u003e\n\u003cli\u003eMavlink radio status reporting (Local RSSI, Remote RSSI, Local Noise, Remote Noise)\u003c\/li\u003e\n\u003cli\u003eAutomatic antenna diversity switching on a packet basis in realtime\u003c\/li\u003e\n\u003cli\u003eAutomatic duty cycle throttling based on radio temperature to avoid overheating\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003e\u003cstrong\u003eCompliance :\u003c\/strong\u003e\u003c\/p\u003e\n\u003cp align=\"center\"\u003eWe declare that the equipment is in conformity with the relevant Union harmonization legislation:\u003c\/p\u003e\n\u003cp align=\"center\"\u003eDirective 2014\/53\/EU on radio equipment\u003c\/p\u003e\n\u003cp\u003eThe RFD868x-EU is compliant with the following standards:\u003c\/p\u003e\n\u003cul\u003e\n\u003cli\u003eEN 301 489-3 V2.1.1\u003c\/li\u003e\n\u003cli\u003eEN 300 220-2 V3.1.1\u003c\/li\u003e\n\u003cli\u003eEN 62311:2008\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003eRelevant docs for UK users\u003cspan\u003e \u003c\/span\u003e\u003ca href=\"https:\/\/www.ofcom.org.uk\/__data\/assets\/pdf_file\/0028\/84970\/ir-2030.pdf\" rel=\"noopener noreferrer\" target=\"_blank\"\u003eIR 2030\u003c\/a\u003e\u003cspan\u003e \u003c\/span\u003e\u003ca href=\"https:\/\/www.legislation.gov.uk\/uksi\/2017\/1206\/made\" rel=\"noopener noreferrer\" target=\"_blank\"\u003eSI for The Radio Equipment Regulations 2017\u003c\/a\u003e\u003c\/p\u003e","brand":"RF Design","offers":[{"title":"Default Title","offer_id":64745970925917,"sku":"RFD-00049-057","price":280.0,"currency_code":"GBP","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/1013\/9127\/0237\/files\/868x_eu_modem_bundle_01.jpg?v=1779272659","url":"https:\/\/www.3dxr.co.uk\/products\/rfd-868x-eu-radio-modem-uk-and-europe-bundle","provider":"3DXR","version":"1.0","type":"link"}